The Odd Jobs.
The "Can You Fix This?"
The Stuff Other Shops Skip.

Not every job fits into a neat category. Stripped threads that someone else left behind. An alarm system you want wired right. Fairings that need replacing after a tip-over. Carbs that need more than a spray can. If it's not on this page, ask. If we can do it, we will. If we can't, we'll tell you who can.

Small Jobs. Big Headaches. We Handle Them.

Some jobs are too small for a dedicated service page but too important to ignore. A stripped oil drain bolt that leaks a drop every night. A carburetor that's never been properly cleaned. An alarm that's been sitting in the box since Christmas. Fairings cracked from a parking lot tip-over.

These are the jobs riders put off because they don't know who to call. Call us. If we do it, we'll quote you upfront. If we don't, we'll point you to someone who does.

What We Offer

  • Ultrasonic Carb Cleaning — Not a spray-can job. Full disassembly, ultrasonic bath, reassembly, and tuning. Your carbs come back looking and working like new.
  • Stripped Thread Repair — Drain bolts, spark plug holes, caliper mounts. We use inserts, not shortcuts. A proper repair that holds torque.
  • Alarm Installation — Bought a system? We'll wire it correctly. No vampire taps. No electrical tape. Works with your bike's existing wiring.
  • Minor Crash Repairs — Fairing replacement, bent lever swap, broken signal fix. We don't paint, but we can replace what's broken and get your bike looking right again.

Don't see what you need? Contact us. LED installs, USB chargers, fender eliminators, steering bearings, and lowering are covered on our Electrical and Suspension pages.

Ask About Your Job
Ultrasonic Carb Cleaning

Deep clean. Full disassembly. Not a spray can and hope.

Stripped Thread Repair

Drain bolts, spark plug holes, caliper mounts. Fixed properly.

Alarm Installation

Wired correctly. No vampire taps. No electrical tape.

Minor Crash Repairs

Fairings, levers, signals. Replace what's broken. No paint.

Specialty Service Questions

What is ultrasonic carb cleaning?

We fully disassemble your carburetors and run them through an ultrasonic bath — high-frequency sound waves in a cleaning solution that removes varnish, deposits, and blockages from passages you can't reach with a spray can. Then we reassemble, set the float heights, and tune. It's the difference between "it runs" and "it runs right."

Can you fix a stripped oil drain bolt?

Yes. We use threaded inserts — not epoxy, not oversized plugs, not hope. The repair restores the original thread size and holds proper torque. It's a permanent fix, not a temporary patch.

I don't see my job listed. Should I still ask?

Yes. This page covers the most common odd jobs, but we do more. LED installs, USB chargers, and electrical work are on our Electrical page. Lowering, steering bearings, and suspension are on our Suspension page. If you're still not sure, call or text. If we can do it, we'll quote it.

Odd Jobs Welcome

Got Something That Doesn't Fit a Category?

Stripped threads. Dirty carbs. An alarm in a box. Fairings that need swapping. If it's not listed, ask. We'll give you an honest answer and an upfront quote.

Ultrasonic Carb Cleaning Stripped Thread Repair Alarm Install & Crash Repair